Optic Test; Operation Note - FloTech FT555F Mode D'emploi

FloTech FT555F Automatic Overfill System Tester
When the test is complete the Screen will display the PASS / FAIL
status of each test performed.
Step 10) Press the "TEST SELECT" button to move on to a new
test, press "GO" to restart the test, or press the "ON/OFF" button
to turn the tester off.

OPTIC TEST

This test will test the API Optic signal from the trailer mounted
sensors or onboard monitor and report a Pass/ Fail.

OPERATION NOTE:

This test will also report the number of good sensors IF THE
SENSORS ARE WIRED DIRECTLY TO THE SOCKET AND
NO ONBOARD MONITOR IS USED. Should your trailer have
an onboard monitor, the tester will test the Onboard Monitor as
if it were a single sensor. The status of sensor connected to an
Onboard Monitor does not pass through the monitor to the
socket.
Step 1) Move the J-Slot thumb screws to the correct holes to match
the type of socket to be connected. Follow the "O" and "T"
markings on the plug body.
Step 2) Connect the FT555F Automatic Tester to the trailer socket.
Step 3) Press the ON/OFF button to turn on the FT555F Automatic
Tester. When "Press Key" screen appears press "TEST SELECT"
button two times so the "Optic Test" screen appears.
Page 12 10784PA REV C FT555F Truck Tester