Ft555F Automatic Tester; Unpack Unit And Initial Setup - FloTech FT555F Mode D'emploi

FloTech FT555F Automatic Overfill System Tester

Unpack Unit and Initial Setup

Step 1) When unpacking the FT555F Automatic Tester you will
find the following;
a) FT555F Automatic Tester
b) Two "D" size batteries
c) Three J-Slot thumb screws
d) This instruction manual
Step 2) Screw in the three J-Slot Screws into the threads marked
"O" for Optic socket compatibility and into the J-Slot threads
marked "T" for thermistor socket compatibility.
Step 3) Remove the battery door by turning counter clock wise
until door opens. Insert two "D" size batteries with positive
battery terminal facing out of the opening. Reinstall battery door
by turning clockwise.
DO NOT FORCE BATTERY DOOR OPEN OR CLOSE
Step 4) Press ON/OFF button once. The FT555F will show the
Initial System Setup screen shown below;
Step 5) Complete the Initial System Setup following the setup
instructions on page 7.
Page 6 10784PA REV C FT555F Truck Tester