Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FloTech FT555F Automatic Overfill System Tester
FT555F Indicators
A) LCD SCREEN
The LCD screen is the main display where test selection, test results, and
test instructions are displayed. Screen is backlit enabled using the
ON/OFF button.
B) ON/OFF BUTTON
Press this button to turn the FT555F Automatic Tester on and off. The
unit will automatically turn off after 10 minutes. Press and hold this
button for 2 seconds and the backlight will illuminate.
C) TEST SELECT BUTTON
Press this button to cycle through the available tests.
D) GO BUTTON
Press this button to start the selected test.
E) WET TEST BUTTON
Press this button while in the Optic or Thermistor Test mode and the wet
test feature will begin. Pressing any button will stop the wet test.
F) SETUP BUTTON
Press this button to enter the set up screens.
G) BATTERY DOOR
Twist to open, hold two D cells, positive points towards battery door
(out).
H) ALARM
Audible alarm sounds when FT555F Automatic Tester is in WET TEST
mode and sensor is wetted.
I) API PLUG CONNECTOR
API compatible plug with configurable J-Slot pins for both optic and
thermistor sockets.
FT555F Truck Tester
10784PA REV C
Page 5
Publicité
Table des Matières
