FloTech FT555F Mode D'emploi page 31

FloTech FT555F Automatic Overfill System Tester
Step 3) Press the ON/OFF button to turn on the FT555F Automatic
Tester. When "Press Key" screen appears press "TEST SELECT"
button one time so the "Automatic Test" screen appears.
Step 4) Press the "GO" button to start the test. Follow the prompts
listed in the display screen.
Step 5) Move the J slot screws to match the J-Slot configuration of
the optic socket.
Step 6) Connect the tester to the optic socket.
Step 7) Press go button to start the test.
Next the tester will instruct you to connect to the Thermistor
socket.
Step 8) Move the J-Slot Screws to match the configuration of the
Thermistor socket.
Step 9) Connect the tester to the socket and press the go button to
start the test.
The tester will automatically test the ground bolt and TIM module
if these options are enabled in the set up screen.
FT555F Truck Tester 10784PA REV C Page
11