Selecting Test Option; Performing Automatic Test - FloTech FT555F Mode D'emploi

FloTech FT555F Automatic Overfill System Tester
Auto Test Truck ID Module
Press the "GO" button to ENABLE or DISABLE the Truck ID
Module test during the automatic testing. PRESS "TEST
SELECT" button to exit the SETUP mode and return you to the
"PRESS KEY TEST SELECT" screen.

SELECTING TEST OPTION

When at the "Press Key" screen, each time the TEST SELECT
button is pressed the tester will cycle through each of the five
available testing modes.
AUTOMATIC TEST
OPTIC TEST
THERMISTOR TEST
GROUND BOLT TEST
TRAILER ID MODULE TEST

PERFORMING AUTOMATIC TEST

FUCTION
This test option will automatically test all of the available test
options previously enabled in the setup procedure above, and
report the findings in a PASS / FAIL screen.
Step 1) Move the J-Slot thumb screws to the correct holes to match
the type of socket to be connected. Follow the "O" and "T"
markings on the plug body.
Step 2) Connect the FT555F Automatic Tester to the trailer socket.
Page 10 10784PA REV C FT555F Truck Tester