5. Assembly / Dismantling - Austro Flamm IRONY L Manuel

deutsch
5. ASSEMBLY- / DISMANTLING INSTRUCTIONS
Transport safety screws
The transport safety unit for the sliding door is
removed by cutting through the cable binder that
can be seen in the wood storage compartment at
the left rear.
Cladding
The following cladding units can be removed for
easier transport:
1. Lift the perforated plates (Items 4 and 5) from
the front and rear cast covers (Item 1and 3)
2. Lift and remove the front cast cover (Item 1)
with the cover ceramic units (Items 7 and 8).
3. Open the side cladding units by lifting the locks
(Item 12).
4. Open the side cladding units (Items 10 and 11)
and remove them by lifting them out of
position.
5. In order to avoid damaging the ash collection
tray (Item 6) and/or the pedestal segment in
the front (Item 9), remove them by lifting them
out of their positions toward the front.
4
1
2
Fig. 6: Cover
5 3
8
The above components are re-assembled in the
reverse order.
Fig. 7: Cladding components
Irony L
7 8
11
9 6