Maintenance And Adjusting - Christopeit Sport CS 1000 Notice De Montage Et D'utilisation

GB

MAINTENANCE AND ADJUSTING

1. Lubrication for the running belt:
In order to keep the machine in the best condition, please add some
Silicone oil between the running belt and the running board after 50
hours or 1 to 2 month of use. But the running belt may slip, if you lu-
bricate too much. To lubricate the belt please pull the walking belt up
and injection the silicone oil into the gap between belt and walking
deck.
2. Adjusting running belt:
You need to adjust the walking belt to the normal position, per the fol-
lowing steps if it is off.
a. Set speed at 3-5km.
b. Using the Allen key to adjust the belt tension bolt on the end cap of
the system frame.
50
c. If you want to move the belt towards left, turn the right tension bolt
clockwise.
d. If you want to move the belt towards right, turn the left tension bolt
clockwise.
e. If you have already done according to the steps above and it is still
not at the good range, then the running belt should be damaged alrea-
dy, please contact your local dealer for replacement.
Note: Make sure that the running surface is as centered as possible.
Once these moves too far from the center, (about 10 mm) it should be
readjusted into the center.
3. Running belt slips:
a. Make sure the walking belt is not too loose.
b. Make sure the motor belt is not too loose.
4. No light on the Display:
a. Check if the power plug is properly connected.
b. Check if the safety key at handrail is in place.
5. Overload protection:
The fuse compartment (B) is located between the main switch (A) and
the mains connection socket (C) for the main connection. There is a mi-
crofuse 5x20mm with the data 5A/250V.
6. Abnormal noise from the machine:
a. Check if any screw of machine is loose.
b. Check if the motor belt is off.
c. Check if the running belt is off.
Note: Please contact your local dealer if you have checked all the ab-
ove listed things but the problem is still there.
7. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use benzene,
thinner or other aggressive cleaning agents for surface cleaning as this
damage caused. The device is only for private home use and for use
suitable indoors. Keep the unit clean and moisture from the device.
8. Storage
Fold in the handle. Unplug the power cord if you don't intend to use
the device for more than 4 weeks. Choose a dry indoor storage loca-
tion. You can store the treadmill lying down or leaning against the wall
in an upright position on the stand up foots. Cover the device to pro-
tect it from discoloration from possible sunlight and dust.
12