Unpacking And Operation - Christopeit Sport CS 1000 Notice De Montage Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

UNPACKING AND OPERATION

Before usage, observe our recommendations and safety instructions.
STEP 1:
Remove the treadmill
1. Remove small parts, loose packing material out of the box and
then take out with help of a second person the preassembled frame
of packaging. Put your hands below the main frame (51) and take care
of no squeezing.
STEP 2:
Unfold the handrail
1. Lift the safety handrail (43) from the lying position until it engages
with the left damper. Hold the safety handrail (43) firmly during the
entire folding process, as the dampers exert corresponding force on
the safety handrail (43).
STEP 3:
Fold up the handrail
1. To fold the safety handrail (43) back, press the orange part of the
left damper (21) with your foot so that the handle is unlocked and move
the safety handrail (43) to the lying end position. Caution hold the safe-
ty handrail (43) as the dampers exert force on the safety handrail (43)
Attention: We always recommend training with a safety handrail (43)
in upright position and with safety clip so it may give help you during a
dangerous situation / emergency descent and the treadmill stops
STEP 4:
Transportation the treadmill
1. Turn off the treadmill and disconnect the power cord.
2. Only lift the treadmill at the rear end until the treadmill stands on
the front transport rollers (44) and it is easy to move.
Attention:
Before folding the treadmill, switch off the treadmill and wait until the
surface fully stops
STEP 5:
Checks and How to start
1. When everything is in order, connect the power supply cable (57)
with wall power (220-240V~50-60Hz) and socket on the main switch
(46) below the front frame.
2. Put the safety key (15) onto the safety handrail (43) and the com-
puter will show normal manual mode. Carefully remove the protective
film from the display. Put the safety clip (15) at your exercising cloth
and stand on the side rails (26+36).
3. Insert the battery into the remote control (53), observing the po-
larity. Press „ "-button and after a 3 sec. Count Down the treadmill
start moving. Start walking onto the walk surface (34) when speed is
slowly and follow the speed. Familiarize yourself with the machine at
low speed settings.Run in the middle of the running surface (34) and
hold yourself tight at safety handrail (43) if you feel insecure. Don't
step on the side foot rails (26+36). Only run with look at the comput-
er (1) on the treadmill during the running. In emergency case, step of
the treadmill lateral and hold onto the safety handrail (43).
Note:
Please keep the instructions in a safe place as it may be required for
repairs or spare parts orders becoming necessary later.
43
21
26
34
36
11
51
43
15
53
43
GB
44
1
46
57

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

20252025 a

Table des Matières