Seal The Case; Attach The Special Balance Weight (Optionally Available) - Olympus PT-037 Mode D'emploi

Seal the Case.

Lock the two buckles in the following
order as shown in the figure.
1 First close the buckle on the side
of the Case.
2 Then close the buckle on the
upper part of the Case.
If the buckles are closed in the
reverse order, excessive force may
damage the equipment.
Close the rear lid (gently so that the
O-ring does not come out of the
groove). Hook the buckles on the
edge of the rear lid and close each
buckle open/close lever in the
direction of the arrow to seal the
Case completely.
CAUTION:
• Seal the Case completely by tilting both buckle lock/unlock levers in the
directions indicated by respective arrows.
• If either buckle is unlocked, the Case is not sealed completely and water
may penetrate into the Case.
• Be careful not to catch the LCD hood and the lens cap strap when closing
the rear lid of the Case. Otherwise, water leak may result.
• When opening the Case again, unlock the buckles in the reverse order to
locking.

Attach the special balance weight (optionally available).

Attach the dedicated balance weight
on the tripod seat on the bottom of
the Case. Be sure to attach the
balance weight tightly using the
provided screw.
EN
EN 23