Olympus PT-037 Mode D'emploi page 83

5 Deterioration of the O-ring is accelerated by the use conditions
and the storage conditions. Replace the O-ring immediately with
a new one if it shows signs of damage, crack or loss of elasticity.
Q10: What are the important points for Case maintenance?
A10: Pay special attention to the following items.
1 Never use the following chemicals for cleaning, corrosion
protection, defogging, repair or other purposes.
• Never use alcohol, thinner, benzene or similar volatile
organic solvents or chemical detergents to clean the Case.
Pure water or lukewarm water is sufficient for cleaning.
• Do not use anticorrosion agents on the metal parts. The
metal parts are made of aluminum, brass or stainless steel.
Cleaning with pure water is sufficient.
• Do not use commercial defogging agents. Always use the
genuine Olympus defogging silica gel.
• Do not use adhesive for repairs or other purposes. When
repair is required, please contact a service station of our
company or your dealer.
Q11: Please tell me how to use the light cable connector?
A11: Use this connector when connecting the flash through a non-
Olympus cable.
Q12: Please tell me about repairs.
A12: When repair is required, please contact a service station of our
company or your dealer. Do not try to repair, disassemble or modify
the Case yourself. Repair, disassembly or modification by you or
third parties not authorized by Olympus invalidates the guarantee.
Q13: What are the model names of the accessories for the PT-037?
A13: The following accessories are being sold.
1 O-rings for the PT-037 body (POL-037A for front lid, POL-037B
for the rear lid): This is a silicone rubber O-ring packing to be
installed in the PT-037 body to make it waterproof. O-rings for
other Case models cannot be used.
2 Silicone O-ring grease (PSOLG-1): This is a special grease for
silicone O-ring maintenance.
EN
EN 41