Setting The Zoom Lever; How To Use The Power Button - Olympus PT-037 Mode D'emploi

Setting the Zoom Lever

When loading the digital camera in the Case, fit the projecting part of the
zoom lever of the digital camera into the recessed part of the zoom lever
on the inside of the Case.
EN
CAUTION:
When loading the camera, confirm that the projecting part of the zoom lever
of the camera is properly set to the recessed part of the zoom lever of the
Case. When the setting is insufficient, the loading of the camera becomes
imperfect and it may not be possible to seal the Case or zooming may not
function. Insufficient sealing will cause water leakage.

How to Use the POWER Button

Press the POWER button to turn the
camera ON/OFF.
CAUTION:
To save battery power, the camera automatically goes into sleep mode and
the monitor turns off if there is no operation when the camera is turned on.
In this mode, no picture can be taken even if the shutter lever is fully pressed.
Operate the zoom lever or other buttons to restore the camera from sleep
mode before taking a picture. If the camera is left for 12 minutes, it
automatically turns off. Press POWER button to turn the camera on.
For details, refer to your digital camera's instruction manual.
EN 16
POWER button