Federal Signal STREAMLINE LP7 Instructions D'installation Et D'entretien page 3

II. INSTALLATION
A. Unpacking
After unpacking the sounder, examine it for damage that may have occurred in
transit. If equipment has been damaged, do not attempt to install or operate it. File a
claim immediately with the carrier stating the extent of the damage. Carefully check
all envelopes, shipping labels and tags before removing or destroying them.
B. Mounting Arrangements
To access mounting holes and electrical connections turn over the LP7 so the strobe
lens is facing down. Twist the base counter-clockwise to remove.
The base of the LP7 provides six (6) slotted recesses for mounting, and one 15/32
inch cable access hole.
C. Electrical Connections
To avoid electrical shock, do not attempt to connect wires when power is on.
A terminal block is supplied on the LP7 for field wiring. Strip 1/2 inch of insulation
from the wiring leads. Attach the appropriate wires to the corresponding terminals.
Tighten the screws to insure that the wires are firmly held in place. The terminals
will accept conductor sizes 24 AWG to 14 AWG.
III. TESTING/OPERATING
Under certain conditions these devices are capable of producing sound loud enough to
cause hearing damage. Adequate hearing protection should be worn if standing within
close proximity to the device while testing. Recommendations in OSHA Sound
After completion of installation be sure to test the system to verify that each sounder
unit operates satisfactory.
After completion of initial system test, a program for periodic testing of this device
should be established.
Provide a copy of these instructions for the Safety Engineer(s), System Operators(s)
and Maintenance personnel.
Although your warning system is operating properly it may not be completely effective.
People may not hear or heed your warning signal. You must recognize this fact and en-
sure that your warning signal achieves its intended effect through proper test/training
Level Standard (29CFR 1910) should not be exceeded.
SAFETY MESSAGE TO OPERATORS
sequences suitable for your specific application(s).
D
ANGER
WARNING
-2-