Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5. ABD APPLICATIONS
5.1 NORMAL WEIGHING MODE
5.1.1 EQUIPMENT CONFIGURATION
5.1.2 FIRST CALIBRATION
5.1.3 USE
5.2 PIECE COUNTING MODE
5.2.1 EQUIPMENT CONFIGURATION
5.2.2 FIRST CALIBRATION
5.2.3 USE
5.3 LIMITS AND ALARM
5.4 UNIT RANGE/ MULTI RANGE/ MULTI INTERVAL
5.1 NORMAL WEIGHING MODE
5.1.1 CONFIGURATION OF THE EQUIPMENT
See section LF2 of the technical parameters
5.1.2
FIRST CALIBRATION
See section LF1 of the technical parameters
5.1.3
USE
Switch on the equipment when all the parameters have been correctly configured and the equipment has been calibrated
Make sure than the value of the indicator, without load on the platform, is 0. If this is not the case, press
•
Place the weight on the platform and the platform will show the weight.
•
The accumulation and sending of data will depend on the mode chosen in the section
•
5.2 PIECE COUNTING MODE
5.2.1 CONFIGURATION OF THE EQUIPMENT
See section LF2 of the technical parameters
5.2.2 FIRST CALIBRATION
See section LF1 of the technical parameters
5.2.3 USE
Switch on the equipment when all the parameters have been correctly configured. Make sure that the value on the visor, with no load on
the platform, is 0. If this is not the case press the key
STEPS TO FOLLOW;
Press the key
1.
Press the key
2.
C50/C100/C200.
Place the sample on the platform, and wait until the sign of stability and press the key
3.
4.
Place the product on the platform and the screen will show the number of pieces
The accumulation and the sending of data will depend on the mode chosen in the section UF-6.
To turn to the normal weighing mode, press the key
•
If the user wants to go back to the piece counting mode, using the same sample of reference, press the key
•
If the user want to change the sample of reference, the user must repeat the steps described above.
•
5.3 LIMITS AND ALARM
The user can configure the superior and inferior limits of the sample placed on the platform.
The display will show if the sample is lower to the inferior limit Lo, above the superior limit
The user can configure when he wants to make the alarm ring and the stability needed to make it happen.
All the procedure is described in the section UF-2.
If the user wants to define the limits in the normal weighing mode and wants to use the limits in piece counting mode, he must define
the new limits for this mode, when it changes to weight mode again, the user will recover the limits he already has. The same happens
otherwise.
30
until the symbol
PCS
appears on the screen.
successively to choose the quantity of pieces of the sample. On the screen will appear, successively, C10/C20/
.
.
Hi
USER'S MANUAL ABD
.
UF-6
.
again.
or in the zone between the two limits
EN
OK
Publicité
Table des Matières
