Black & Decker FD1620 Traduction Des Instructions D'origine page 7

Assembly
Note: Make sure your fan is switched off before connecting
to or disconnecting frompower supply.
Warning! Never use the fan without the guard in place or if
the guard is damaged.
Assembling the base and stand
• Remove the washer (15) and screw (16) from the
support tube by turning it anti-clockwise.
• Place the support tube into the base. Re-insert the
screw into the support tube from underneath. Tighten
the screw by turning it clockwise.
Fitting the fan to the stand
• Remove the screw from the bottom of the fan unit by
turning it anti-clockwise.
• Place the fan unit onto the top of the support tube.
Re-insert the screw into the fan unit. Tighten the screw
by turning it clockwise.
Fitting the fan blade and guard
• Remove the guard nut from the motor shaft by turning it
anti-clockwise.
• Place the rear guard by positioning it on the location
pins on the fan unit. Ensure that the rear guard is in the
correct orientation.
• Secure the guard on to the fan unit by re-fitting the
guard nut. Tighten the guard nut by turning it clockwise.
• Secure the fan blade on the motor shaft by fitting the
blade cap. Tighten the blade cap by turning it
anti-clockwise.
• Place the front guard onto the rear guard by positioning
the top clip on the uppermost part of the rear guard.
Push the top clip down and press the rim of the front
guard onto the rear guard ensuring a tight fit all the way
round.
• Close the bottom clip. Tighten the bottom clip screw by
turning it clockwise.
Use
Warning! Never use the fan without the guard in place or if
the guard is damaged.
Switching on and off
• Your fan has three speed control to keep the desired air
flow through your room.
• 0 - Off
• 1 - Low
• 2 - Medium
• 3 - High
• To switch on, press the button to set the desired speed.
The fan will start.
• To switch off, press the " 0 " button.
(Original instructions)
Oscillation
• The fan can be set to oscillate by pushing Oscillating
Knob downwards.To stop the oscillating feature, pull up
the Oscillation Knob.
Adjusting the angle of the fan
The angle of the fan can be adjusted up and down.
• Tilt the head of the fan to the desired angle.
Adjusting the height of the fan
• Loosen the screw at the top of the support tube by
turning it anti-clockwise.
• Lift the fan to the desired height.
• Tighten the screw at the top of the support tube by
turning it clockwise.
FS1620R Pedestal Fan with remote Control
Features
1. Front Guard
2. Blade Cap
3. Fan Blade
4. Guard Nut
5. Rear Guard
6. Fan Head
7. Guard Screw
8. Fan unit
9. Set Screw
10. Support Tube
11. Base Cover
12. Round Base
13. Base
14. Washer
15. Screw
16. Remote Control
Assembly
Note: Make sure your fan is switched off before connecting to
or disconnecting frompower supply.
Warning! Never use the fan without the guard in place or if
the guard is damaged.
Assembling the base and stand
• Remove the flat washer (14) and screw (15) from the
support tube by turning it anti-clockwise.
• Place the support tube into the base. Re-insert the screw
into the support tube from underneath. Tighten the screw
by turning it clockwise.
Fitting the fan to the stand
• Remove the screw from the bottom of the fan unit by
turning it anti-clockwise.
ENGLISH
7