Removing The Cover - Chicco Baby Hug 4in1 Mode D'emploi

toy before recharging them.
damage the electronic circuit.
adult supervision.

REMOVING THE COVER

put the seat in the horizontal position (crib) and un-
this it is necessary to push the tab inwards and pull
the clip down, repeating this procedure for all clips
(Fig. 27).
28. Pull the restraint system out through the fabric holes
29. Undo the zips along the upper edge (Fig. 28).
30. Disassemble the lateral arm, pushing the pin inwards
and pulling the arm in an outwards direction (Fig.
arm (Fig. 30) and remove from the fabric (Fig. 30a).
CLOSING THE PRODUCT
down on backrest recline lever "N", put the backrest
in a completely horizontal position and remove the
WARNING:
product before closing the frame.
This product complies with Directive
2012/19/EU.
dicates that the product, at the end of its life,
must be disposed of separately from domestic
waste, either by taking it to a separate waste disposal site
for electric and electronic appliances or by returning it
to your dealer when you buy another similar appliance.
cial waste disposal site at the end of its life. If the dis-
used appliance is collected correctly as separate waste,
it can be recycled, treated and disposed of ecologically;
this avoids a negative impact on both the environment
and health, and contributes towards the recycling of the
product's materials. For further information regarding
the waste disposal services available, contact your local
waste disposal agency or the shop where you bought
the appliance.
WARRANTY
fect in normal conditions of use as provided for by the
the case of damage caused by improper use, wear or
accidental events. For the duration of warranty on con-
formity defects please refer to the specific provisions
of national laws applicable in the country of purchase,
where provided.
-
-
-
-
18