System Support - Sky Climber LNX 65X Manuel Utilisateur

 Provide protection below the suspended equipment to prevent injury to personnel
from falling objects.
 Keep all persons from beneath suspended equipment.
 Never work alone on a suspended platform or where aid is not immediately
available in case of an emergency. Maintain contact with your supervisor at all
times.
 Do not overload the hoist. The working load limit (W.L.L.) of the hoist is always
listed on the data plate. This rating includes wire rope, power cord, platform, men
tools and other associated equipment.
 Do not exceed the rated capacity of the platform. Different platform compositions
have different load ratings. (Please refer to the corresponding platform load table as
indicated in the platform manual).
 Check the operation of the fall arrest device at the beginning of each work shift or
as adverse environments require.
 Thoroughly inspect all equipment before use to make sure that it is maintained in a
safe, workable condition. The supervisor should assign a responsible person to do
this at regular intervals.
 In the case of apparent difficulty in the machine, steel wire rope, platform etc.,
notify your nearest authorised Sky Climber representative, and do not use the
equipment until it is repaired or replaced.
 In an emergency situation, press the red emergency stop button. This will cut all
power, stop the operation and will allow the brake of the hoists to set. Do not turn
the emergency switch until the cause has been corrected.
 All suspended access equipment must be handled with care. Impose loads on the
platform gently. Do not drop the hoists on the platform when handling.
 Use only Sky Climber genuine spare parts for your Sky Climber equipment. Do not
alter any Sky Climber Hoists or accessories.
 When at a work station or when getting on or off a suspended working platform,
prevent the platform from moving away from the building or structure by securing the
suspended platform to the building face or structure. Before moving the platform,
always disconnect it from the building face. Hardware may be damaged and
personal injury may result if platform is not disconnected from the building before it
is raised or lowered.

System support

 Make certain the roof, parapet or cornice will support the load imposed by the
suspended platform. Do not secure to a weak or questionable structure. When in
doubt, consult a professional engineer and/or the building owner's qualified
representative.
Power circuit
General
 Do not remove the motor from the hoist unless the platform is safely supported.
74
44UMM001.docx print date 21/06/2016
LNX