Vérification De L'installation - Husqvarna AUTOMOWER 310 Manuel D'utilisation

G
If the guide wire has to be installed on a steep
slope, it is an advantage to lay the wire at an angle
to the slope. This makes it easier for the robotic
lawnmower to follow the guide wire on the slope.
Avoid laying the wire at sharp angles. This can
make it difficult for the robotic lawnmower to follow
the guide wire.
135º
6. Run the guide wire to the point on the boundary loop
where the guide wire is to be connected.
7. Cut the boundary wire using for instance a pair of
wire cutters. Connecting the guide wire is made
easier if an eyelet has been made on the boundary
wire as outlined in the previous description. See
Pose du câble périphériqueà la page19 .
22 - Installation
min. 2 m / 7 ft
90º
135º
8. Connect the guide wire to the boundary wire using a
coupler:
a) Insert the boundary wire and guide wire in the
coupler. Check that the wires are fully inserted
into the coupler so that the ends are visible
through the transparent area on the other side of
the coupler.
b) Use a polygrip to completely compress the
button on the coupler. It does not matter which
holes are used to connect each wire.
9. Staple down or bury the splice in the lawn.
MISE EN GARDE : The guide wire may not
cross the boundary wire, for instance a
boundary wire that is laid out to an island.
3.8 Vérification de l'installation
Vérifiez le signal boucle en inspectant le témoin sur la
station de charge.
473 - 001 - 02.11.2017