Programming Instructions - Fracarro MOD-HDTV Mode D'emploi

Example n° 2

5. PROGRAMMING INSTRUCTIONS

The MOD-HDTV can be programmed in two different ways:
• With display and keys on board the modulator;
• With USB interface, with the appropriate software
Programming via display and buttons on board.
The modulator MOD-HDTV can be programmed using these 4 simple steps using the following procedure:
First Step
Turn on the MOD-HDTV by connecting the appropriate external power supply (12VDC / 1A). The modulator
will need about 20-30 seconds to start up and the seven-segment display will show the progress of the
initialization procedure.
Second Step
After the initialization time, the modulator MOD-HDTV will go to "Channel mode" and the LED "Channel" will
be on. Pressing the "Channel / Profile" you will be able to switch between the "Channel" or "Profile". Set the
desired output RF channel within the channels VHF and UHF E05 ... E12 E21 E69 ... using the "Up / Down".
Wait about 10 seconds for the PLL.
18