Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DVB-T Settings
Through this section the user is able to adjust several parameters of the modulator RF output part, as
described below:
•
Channel - Output channel selection (VHF:5-12 & UHF:21-69).
•
Bandwidth - Bandwidth selection (VHF : 7MHz - UHF: 8MHz).
•
Constellation - Constellation selection (QPSK, QAM-16, QAM-64).
•
Modulation - Modulation selection (2K, 4K, 8K ).
•
Guard Interval - Guard Interval selection (1/4, 1/8, 1/16, 1/32).
•
Code rate - Code rate selection (1/2, 2/3, 3/4, 5/6, 7/8).
Encoder Settings
In this section the user is able to adjust the H.264 encoder parameters, as described below:
•
Input source - Select the primary input source
•
Video BR (Mpbs) - Set the video bitrate
•
Audio BR (Kbps) - Set the audio bitrate
Multiplexer Settings
In this section the user is able to adjust the MOD-HDTV multiplexer's parameters, as described below:
•
Network Name – Enter the Network name
•
Program Name – Enter the Program name
•
Provider Name - Enter the Provider name
•
Original Net ID - Set the Net ID (0-65535)
•
TS ID (*) - Set the Transport Stream ID (0-65535)
•
PMT PID – Set the PID value
•
Video PID – Set the Video PID value
•
Audio PID – Set the Audio PID value
•
LCN No – Set the LCN No (1-999) (must be enabled fi rst)
•
LCN Provider - Set the LCN provider
(*) NOTE: If in the coaxial network are connected many MOD-HDTV modulators, the TS ID must be different
from each other in order to avoid confl icts between them.
22
Publicité
Table des Matières
