Hanging The Fan - Hinkley 44 VENTUS Manuel D'instructions

HANGING THE FAN

Remove ball from downrod by loosening set screw in the
1
side of the ball. Slide ball down and remove ball pin;
remove ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing
2
with the mounting collar (where the wires come out) facing
upward.
Loosen the two security set screws and remove the
3
downrod pin instead of hitch pin from the coupling on top
of the motor assembly. (Fig. 2)
Carefully feed the electrical lead wires from the fan through
4
the downrod. Thread downrod into coupler until holes align.
Insert downrod pin through holes in mounting collar and
downrod; clip cotter pin through small hole in end of
downrod pin to hold downrod in place.
Tighten security set screws against downrod using a large
5
flat blade screwdriver to ensure a tight fit against downrod.
Tighten nuts against mounting collar.
06 | hinkley.com
Cross Pin
Hanger
Ball
Set Screw
Fig. 1
Hook-up
(3) Wires
Downrod
Security Set Screws
Mounting Collar
Cotter Pin
Top of
Fan Body
Fig. 2
Downrod
Downrod Pin