Operation - Hinkley 44 VENTUS Manuel D'instructions

OPERATION

1
Restore power to ceiling fan and test for proper operation.
Remove the face plate of the Wall Switch by lifting at the top
2
and then insert the supplied 12V battery. Duracell
MN21/Eveready A23/GP 23A all 12V. (Fig. 1)
"LO, MED, HI" buttons:
3
These three buttons are used to set the fan speed as follows:
LO= Low speed
MED= Medium speed
HI= High speed
"FAN OFF" button:
4
This button turns the fan off.
The "LIGHT" button are controlled by pressing the light button.
5
Tap button quickly to turn light off or on. Push the button once
and release to turn the light on to full brightness. Hold the
button down to increase or decrease light brightness. Release
the button at the desired light brightness and that setting will
be remembered the next time the light is turned on. The pre-set
brightness can be changed by holding down the light button
again until the new desired brightness is reached.
Range of the transmitter is approximately 25 ft. A new alkaline
6
battery will typically give range of 35 ft. or more.
If power is lost to the fan receiver, the memory will be lost and
all settings will return to the default.
14 | hinkley.com
NOTE:
HI
LIGHT
MED
LOW
FAN OFF
ON ECE
1 2 3 4
Fig. 1
Fig. 2