Electrical Connections - Hinkley 44 VENTUS Manuel D'instructions

ELECTRICAL CONNECTIONS

To avoid possible electrical shock, be sure electricity is
turned off at the main fuse or breaker box before wiring.
Follow the steps below to connect the fan to your household wiring.
1
Use the wire connecting nuts suppled with your fan. Secure the
connectors with electrical tape. Make sure there are no loose wire
strands or connections.
The dip switches on the receiver unit are covered with a rubber cover,
2
remove the rubber cover and then place back after making any
changes to the dip switches.
NOTE: The Remote Control System is equipped with 16 possible
3
frequency combinations to prevent interference from or with other
remote control units. The frequency switches on your receiver and
transmitter have been preset at the factory. Please recheck to make
sure the switches on transmitter and receiver are set to the same
position, any combination of settings will operate the fan as long as
the transmitter and receiver are set to the same position. (Fig. 1)
Insert the receiver into the ceiling mounting bracket with the flat side
4
of the receiver facing the ceiling. (Fig. 2) For best performance, make
sure the Black Antenna, on the end of the receiver, remains extended
and not tangled with any of the electrical wires.
08 | hinkley.com
WARNING:
ON
Code switch
ON ECE
1 2 3 4
HI
LIGHT
MED
LOW
ON ECE
FAN OFF
1 2 3 4
Fig. 1
Receiver
Fig. 2
Hanger
bracket