Hinkley 44 VENTUS Manuel D'instructions page 9

1
Slip the yoke cover, trim ring and canopy onto the downrod.
(Fig. 3)
Thread the hanger ball onto the downrod, insert the cross
2
pin through the downrod and tighten. Tighten the set screw.
Fan has 6 feet of hook-up wire in case you are using
a long extension downrod.
Lift ball/downrod/fan into hanger bracket opening.
3
NOTE: The tab opposite hanger bracket opening should fit
in slot on ball. (Fig. 4)
Make wire connections, (refer to section titled "Electrical
4
Connections").
Slide canopy up and fasten to hanger bracket with 4 screws
5
provided.
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the
safety cable from the fan. Loop the safety cable around the
wood screw that was just attached to ceiling joist. Feed the end
of the cable into the clamp and pull as much cable through as
possible. Firmly tighten screw in the clamp. Cut off excess cable.
NOTE:
Cross pin
Hanger ball
Set screw
Hook-up (3) Wires
Downrod
Yoke cover
Top of
Fan Body
Fig. 3
Wood Ceiling Joist
Safety Cable Clamp
Safety Cable Loop
Wood Screw
And Washer
Safety Cable
Fig. 4
©2019 Hinkley Lighting, Inc. | hinkley.com |
Ground Wire
Canopy
Trim Ring
07