Hanging The Fan - Hinkley CHISEL Manuel D'instruction

HANGING THE FAN

Remove ball from downrod by loosening set screw in the side of the
1
ball. Slide ball down and remove ball pin; remove ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing with the
2
mounting collar (where the wires come out) facing upward.
3 Loosen the two security set screws and remove the downrod pin
and retaining clip from the coupling on top of the motor assembly.
(Fig. 2)
Carefully feed the electrical lead wires and safety cable from the fan
4
through the downrod. Thread downrod into coupler until holes
align. Insert downrod pin through holes in mounting collar and
downrod; clip cotter pin through small hole in end of downrod pin
to hold downrod in place.
Tighten security set screws against downrod using a large at blade
5
screwdriver to ensure a tight t against downrod. Tighten nuts
against mounting collar.
06
| hinkley.com
Cross pin
Hanger
ball
Set screw
Fig. 1
Downrod
Mounting Collar
Security Screws
Cotter Pin
Top of
Fan Body
Fig. 2
Downrod
Downrod Pin