Blade Attachment - Hinkley 902672FMM-NWD Manuel D'instructions

BLADE ATTACHMENT

NOTE:
Remove any rubber supports that are installed for
shipping.
Place fiber washer on screw. Insert this assembly through
1
the blade and start the screw into the blade arm. Repeat
this procedure without tightening the screw until all 3
screws have been started into the blade arm (Fig. 1).
Tighten each screw starting with center screw.
2
Fasten blade assembly to motor with provided screws and
3
lock lockwashers. Repeat procedure for remaining blades
(Fig. 2). Make sure screws are TIGHT! Loose motor screws
can contribute to unnecessary hum during operation.
Cordless power screwdrivers are NOT recommended, as
they usually strip the heads of the screws and usually will not
fully compress the lock washers on the motor screws. Use a
large flat blade screwdriver for final tightening to fully
compress the washers. This will help ensure proper
alignment of the blades and noise-free, wobble-free running.
10 | hinkley.com
NOTE:
Screw
Fiber Washer
Blade Arm
Fig. 1
Screws
Blades
Assembly
Fig. 2
Blade