Blade Attachment - Hinkley CABANA Manuel D'utilisation

BLADE ATTACHMENT

NOTE:
Remove any rubber supports that are installed for
shipping.
1 Place fiber washer on screw. Insert this assembly through the
blade and start the screw into the blade arm. Repeat this
procedure without tightening the screw until all 3 screws have
been started into the blade arm (Fig. 1).
2
Tighten each screw starting with center screw.
Fasten blade assembly to motor with provided screws and
3
lock lockwashers. Repeat procedure for remaining blades (Fig.
2). Make sure screws are TIGHT! Loose motor screws can
contribute to unnecessary hum during operation.
NOTE:
Cordless power screwdrivers are NOT recommended, as they
usually strip the heads of the screws and usually will not fully
compress the lock washers on the motor screws. Use a large
flat blade screwdriver for final tightening to fully compress the
washers. This will help ensure proper alignment of the blades
and noise-free, wobble-free running.
Screw
Fiber Washer
Blade Arm
Fig. 1
Screws
Fig. 2
©2019 Hinkley Lighting, Inc. | hinkley.com |
Blade
Blades Assembly
11