Blade Attachment - Hinkley 60 CHISEL Manuel D'instructions

BLADE ATTACHMENT

Flat Washers
10
| hinkley.com
Blades
Lock Washers
Screws
NOTE:
Remove any rubber supports that are installed for
shipping.
Fasten blade to motor with provided screws, lock washers and ˝at
washers. Repeat procedure for remaining blades. Make sure screws are
TIGHT! Loose motor screws can contribute to unnecessary hum during
operation.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large ˝at blade screwdriver
for ÿnal tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.