Blade Attachment - Hinkley 52 OASIS Manuel D'instructions

BLADE ATTACHMENT

10 | hinkley.com
Blades
Screws
Blade Arms
NOTE:
Remove any rubber supports that are installed for
shipping.
Place rubber washer on screw. Insert this assembly
1
through the blade and start the screw into the blade
arm. Repeat this procedure without tightening the
screw until all 3 screws have been started into the
blade arm.
2 Tighten each screw starting with center screw.
Fasten blade assembly to motor with provided
3
screws and lockwashers. Repeat procedure for
remaining blades. Make sure screws are TIGHT!
Screws
Loose motor screws can contribute to unnecessary
Rubber
hum during operation.
Washers
Cordless power screwdrivers are
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large flat blade screwdriver
for final tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.
NOTE:
NOT recommended,