Blade Attachment - Hinkley 60 SCULPT Manuel D'utilisation

BLADE ATTACHMENT

Adapter Plate
Flat Washers
10
| hinkley.com
Blades
Lock Washers
Screws
NOTE:
Remove any rubber supports that are installed for
shipping.
Assemble blade to motor with provided screws, lock washers and at
washers. Repeat procedure for all blades. Make sure screws are TIGHT!
Loose motor screws can contribute to unnecessary wobble or fan noise.
NOTE:
Cordless power screwdrivers are NOT recommended,
as they usually strip the heads of the screws and
usually will not fully compress the lock washers on
the motor screws. Use a large at blade screwdriver
for nal tightening to fully compress the washers. This
will help ensure proper alignment of the blades and
noise-free, wobble-free running.