Installing The Led Assembly And Glass Shade - Hinkley 60 SCULPT Manuel D'utilisation

INSTALLING THE LED ASSEMBLY AND GLASS SHADE

Light Wires
LED Assembly
Fig. 1
NOTE: Be sure the power is o before installing.
Aligning all 3 holes in LED Assembly with 3 holes
1
in the Mounting Hub make sure all screws are tight
(Fig.1)
Connect 2-wire plug from fan to 2-wire plug
2
from LED Assembly. Make sure plugs snap together
completely.(Fig.2)
3
Raise the glass shade against the LED Assembly and turn
clockwise until snug, DO NOT OVERTIGHTEN.
Restore power and your light kit is ready for operation.
Wire connectors
Mounting Hub
(bottom of motor)
Screws
Fig. 2
5
LED
Assembly
Glass shade
©2019 Hinkley Lighting, Inc.
11
| hinkley.com |