Installation Of Removable Switch Housing - Hinkley 52 OASIS Manuel D'instructions

INSTALLATION OF REMOVABLE SWITCH HOUSING

Fig. 1
NOTE: Be sure the power is off before installing.
1
Carefully place the rubber cap to mounting plate (Fig. 1)
Wire Connectors
Detachable
Switch Housing
Fig. 2
2
Connect the plug and receptacle and make sure side buckle
snaps in place. (Fig. 2)
Tuck connections neatly into mounting plate. Place the key
3
holes on the light kit over the 2 screws previously loosened,
turn the light kit until it locks in place at the narrow section of
the key holes. Secure by tightening the 2 screws previously
5
loosened and the one previously removed.
4
Attach pull chain fob to end of the switch's pull chain.
5
Restore power and your light kit is ready for operation.
Mounting Plate
©2019 Hinkley Lighting, Inc. | hinkley.com |
11