Door Removal Instructions - Kenmore 970-7030 Serie Guide D'utilisation Et D'entretien

Door Removal Instructions

Getting Through Narrow Spaces
If your refrigerator will not fit through an
entrance area, you can remove the doors.
Check first by measuring the entrance.
To prepare for removing the doors:
1. Make sure the electrical power cord
is unplugged from the wall outlet.
2. Open the freezer drawer and remove
the toe grille (see "Installation" section).
3. Remove any food from the door shelves
and close the doors.
To remove the top hinge covers:
1. Remove the two screws from each
cover over the top door hinges.
2. Lift inside edge of hinge cover and
tilt back.
Front
cover screw
Top hinge
cover
Hinge
screws
Multi-wire
cables
Leave
hinge
with
door
Front
Rear
Cover Screw
Cover
Screw
Ground
Top
Screw
Hinge
NOTE
DO NOT remove the ground screw
from hinge.
All manuals and user guides at all-guides.com
To remove the refrigerator doors:
1. Trace lightly around the door's top
2. Disconnect the harness by grasping
Rear
cover
screw
Ground
screw
Top
hinge
3. Unscrew the three lower hinge screws
To reinstall the right door, reverse the
Top Hinge
Cover
above steps.
Hinge
Screws
Two Wire
Cables
Leave
Hinge
With
Door
12
hinges with a pencil. This makes
reinstallation easier.
both sides of the connector firmly,
depress the latch, and pull apart.
Remove the two screws from the top
hinge. Lift the door off of the bottom
hinge and set it aside.
and hinge if necessary.
Lower Hinge Removal