Before You Call - Kenmore 970-7030 Serie Guide D'utilisation Et D'entretien

Before You Call

CONCERN POTENTIAL CAUSE
AUTOMATIC ICE MAKER
Ice maker is • Ice maker is turned off.
not making
any ice.
• Refrigerator is not
connected to water line or
water valve is not open.
• The water supply line
is kinked.
• The water filter is not
seated properly.
• The water filter may
be clogged with
foreign material.
• Saddle valve on cold
water pipe is clogged
or restricted by foreign
material.
Ice maker is • Ice maker is producing
not making less ice than you
enough ice. expect.
• The water filter may
be clogged with
foreign material.
• The water supply line
is kinked.
• Saddle valve on cold
water pipe is clogged
or restricted by foreign
material.
Freezer ice • Ice maker wire
maker will signal arm is being
not stop held down by some
making ice. package in the freezer
that has fallen against
the ice maker.
All manuals and user guides at all-guides.com
• Turn on ice maker. For the freezer ice
• Connect the unit to the household water
• Ensure that the supply line does not kink
• Remove and reinstall the water filter. Be
• If water dispenses slowly or not at all,
• Turn off household water line valve.
• Freezer ice makers will produce
• If water dispenses slower than normal,
• Ensure that the supply line does not kink
• Turn off household water line valve.
• Move the item and release wire signal
33
COMMON SOLUTION
maker, lower the wire signal arm.
supply and ensure the supply valve is
open.
when the refrigerator is pushed into
place against the wall.
sure to push the filter firmly so that you
hear it lock solidly into position.
or if the filter is six months old or older,
it should be replaced.
Remove valve. Ensure that valve is not a
self-piercing saddle valve. Clean valve.
Replace valve if necessary.
approximately 2.5 pounds of ice every
24 hours depending on usage conditions.
or if the filter is six months old or older,
it should be replaced.
when the refrigerator is pushed into
place against the wall.
Remove valve. Ensure that valve is not a
self-piercing saddle valve. Clean valve.
Replace valve if necessary.
arm. Remove any ice cubes that may
have frozen together over the wire
signal arm.