Changing The Filter; Water Filter - Kenmore 970-7030 Serie Guide D'utilisation Et D'entretien

Changing the Filter

Locating the Filters
Your refrigerator is equipped with water
filtering system. The water filter system
filters all dispensed drinking water, as well
as the water used to produce ice.

Water Filter

The water filter is located at the top right
side of the fresh food compartment.
Replacing the Water Filter
In general, you should change the water
filter every six months to ensure the highest
possible water quality. Water Filter Status
on the user interface prompts you to replace
the filter after a standard amount of water
(200 gallons/757 liters for Kenmorepure!
has flowed through the system.
If your refrigerator has not been used
for a period of time (during moving
for example), change the filter before
reinstalling the refrigerator.
Filter Cartridge
Ordering Replacement Filters
To order your replacement filters, please
visit the dealer where you purchased your
refrigerator. Sears recommends that you
order extra filters when you first install
your refrigerator, and that you replace
your filters at least once every six months.
Here is the product number to request
when ordering:
Kenmorepure!
Part #9919
NOTE
When ordering your replacement filter,
please reorder the same filter type that
is currently in your refrigerator.
All manuals and user guides at all-guides.com
More about your Advanced Water Filter
Do not use with water that is
microbiologically unsafe or of unknown
quality without adequate disinfection
before or after the system. Systems
certified for cyst reduction may be used
on disinfected waters that may contain
filterable cysts.
Test & Certification Results:
TM )
• Rated Capacity - 200 gallons/757 liters
• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds
• Recommended Minimum Operating
To Replace your Kenmorepure!
Water Filter:
It is not necessary to turn the water supply
off to change the filter. Be ready to wipe
up any small amounts of water released
during the filter replacement.
3. Slide the old water filter cartridge
4. Unpackage the new filter cartridge.
Water Filter
TM
5. Push firmly until the cartridge snaps
26
The Kenmorepure!
water filter system is tested
and certified to NSF/ANSI
Standards 42 and 53 for the
reduction of claims specified on
the performance data sheet.
for Kenmorepure! ice and water filter
TM
per square inch
Pressure: 30 pounds per square inch
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the
end/face of the filter.
straight out of the housing and
discard it.
Using the alignment guide, slide it
gently into the filter housing until it
stops against the snap-in connector
at the back of the housing.
into place (you should hear a click
as the cartridge engages the snap-in
connector).
TM ice and
TM