Performance Data Sheets - Watts Premier 500320 UV-3 Manuel D'installation, D'utilisation Et D'entretien

GENERAL USE CONDITIONS:
1: System to be used with municipal or well water sources treated and tested on regular basis to insure bacteriological safe
quality. DO NOT use with water that is micro biologically unsafe or of unknown quality without adequate disinfection
before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable
cysts.
2: Operating Temperature:
3: Operating Water Pressure:
4: Maximum flow Rate:
5: Rated Capacity:
6: Turbidity
RECOMMENDED REPLACEMENT PARTS AND CHANGE INTERVAL:
Note: Depending on incoming feed water conditions replacement time frame may vary.
Description
Stage 1: Sediment: 5M-10
Stage 2: Carbon block
Stage 3: UV Bulb
This system has been tested according to NSF/ANSI Standard 53 for the reduction of the substances listed below. The
concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal
to the permissible limit for water leaving the system, as specified in NSF/ANSI 53. Testing performed under standard
laboratory conditions, actual performance may vary.
Substance
CRYPTOSPORIDIUM (see Cyst)
CYST
LEAD pH 6.5
LEAD pH 8.5
All manuals and user guides at all-guides.com
Performance Data Sheet
Premier Inc.
8716 W Ludlow Drive Suite #1
Peoria, AZ 85381
UV-3
Maximum 100 F (40.5
o
Maximum 85-psi (5.98 kg/cm
0.50 gpm (1.89 lpm)
600 Gallons (2,200 liters)
< 5 NTU
Part Number
104017
101015
170016
Reduction
10
C) Minimum 40
o
) Minimum 20-psi
2
Change time Frame
6 Months or 600 gallons of water
6 Months or 600 gallons of water
12 Months or 9000 Hours
Influent Challenge
Percent
Concentration
(mg/L unless noted)
99.99% minimum 50,000/mL
99.99% minimum 50,000/mL
99% 0.15 +/- 10%
99% 0.15 +/- 10%
F (4.4 C)
o o
Maximum Permissible
Product Water
Concentration
99.95%
99.95%
0.010
0.010