Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operational Parameters
Installation needs to comply with state and local plumbing regulations.
Operational Temperature
Operating Pressure
pH Parameters
Flow Rate
Contents of Under Counter System
1 UV Unit - Filters Pre-installed
1 Transformer
1 Parts Bag
1 Faucet Assembly
If any of the items are missing, please contact Premier prior to installing
Tools Recommended For Installation
A small knife
Variable speed drill
1/8" (3mm), 1/4" (6.4 mm) and 7/16" (11.0mm) drill bits
1/2" Diamond Tip Drill bit (for porcelain sinks)
1/2" hole punch (for stainless steel sinks)
1/2" and 5/8" open-end wrenches (or adjustable wrenches)
Phillips screwdriver
Installation
This system has been designed to fit under most kitchen sinks. Please read the entire manual carefully
before proceeding with installation.
Step 1: Mounting System Under Sink
(A) Locate a space under the sink that
allows the unit to be mounted close
to the cold water supply and allows
for easy access during maintenance
and filter changes. System must
be installed to the cold water supply
only. Allow approximately 2" (5cm)
clearance between the bottom of the
filter housing and the floor of the sink
cabinet.
(B) Using the mounting holes on the
bracket, mark the location for the
mounting screws on the cabinet wall
under the sink.
(C) Screw the (2) screws into the wall at
the marked location.
(D) Hang the module on the screws using
the mounting holes in the bracket.
All manuals and user guides at all-guides.com
Maximum
100°F (37.8°C)
85 psi (5.98 kg/cm²)
10
0.5 GPM @ 60 psig
4
Minimum
40°F (4.4°C)
20 psi (1.406 kg/cm²)
5
UV Under Counter
Sink
Green
Tubing
COLD
HOT
Counter Top
Blue
Tubing
Sediment Carbon
Publicité
Table des Matières
