Overview; System Maintenance; Equipment Specifications; Operational Parameters And Feed Water Guidelines - Watts Big Bubba Manuel D'installation, D'utilisation Et D'entretien

Overview

Thank you for your purchase of this quality Water Treatment sys-
tem solution.
Your new system is equipped with a high capacity carbon
block filter cartridge with Lead, PFOA/PFOS, Cysts, Sediment,
Chlorine and Chloramine reduction capability. Another great fea-
ture of this system is the volumetric flow monitor that alerts you
when the filter cartridge needs to be changed based on water
usage. The BB-S100 water filtration system provides clean,
clear, great tasting water to your entire home and has a 84,480
gallon filtration capacity for the reduction of Lead and PFOA/
PFOS. The system is certified to reduce Lead (soluble and insol-
uble), PFOA/PFOS, Cysts, and Chlorine.
This system is designed for point of entry installation for whole
home treatment and to be simple and convenient to service.

System Maintenance

It is important to change the filter cartridge at the recommend-
ed interval indicated in this manual. Many contaminants are not
detectable by taste. In addition, other bad tastes and odors may
become apparent over time if the filter cartridge is not replaced
when needed.
Should you have any further questions, please call our customer
service (978) 689-6066 or your Watts representative.

Equipment Specifications

This Watts water filtration system is complete, and self-con-
tained, with the filter cartridge pre-installed in the filter housing.
Some light assembly is required to install plumbing adaptors,
volumetric flow monitor and inline flow meter. Please review oper-
ating pressures, temperatures and water chemistry limitations to
ensure compatibility and performance.
4
IOM-WQ-BB-S100
2130
Operational Parameters and
Feed Water Guidelines
NOTICE
Installation must comply with state and local plumbing regula-
tions.
Please review operating pressures, temperatures and water
chemistry limitations to ensure compatibility.
pH . . . . . . . . . . . . . . . . . . . . 6.5 to 8.5
Min/Max Water Pressure . . . . 25psi to 125psi /172 kPa to
Min/Max Water Temperature . . 34 to 125°F / 1 to 52°C
Free Chlorine (maximum) . . . . 2.0 mg/L
Iron (maximum) . . . . . . . . . . . . 0.3 mg/L
Manganese (maximum) . . . . . 0.05 mg/L
Oil and H2S . . . . . . . . . . . . . . None Allowed
Turbidity/Sediment . . . . . . . . . Pre-filter inlet water with 5 micron
System Electrical
Requirements . . . . . . . . . . . . . 2 AA Alkaline Batteries
For all other guideline information please contact your Watts
representative. Water that does not meet the above guidelines
will require additional pre-treatment.
EDP# 68110146
861 kPa
(125°F / 52°C at 80psi
maximum pressure)
sediment filter if sediment/turbid-
ity prevents BB-S100 filter car-
tridge from achieving full volume
capacity
© 2021 Watts