Important Guidelines - Watts Premier 500320 UV-3 Manuel D'installation, D'utilisation Et D'entretien

Important guidelines

Do not unplug UV unit from power supply. Turning system off & on will shorten the life of the
UV lamp. UV should be on continuously for maximum effectiveness.
The system requires a warm-up period for proper operation. Wait 20 minutes after plugging
in the system before using water.
Water not drawn from unit for a period of time may have a taste or odor and will be warm. To
avoid this, allow water to run through the system for one minute before using.
Replacement filters for this and many other filtration systems can be purchased directly
from Premier. Ordering options include mail order, telephone ordering, and online filter
replacement. Additionally, Premier sells filtration and reverse osmosis systems suitable for
almost any individual or commercial application.
Annual Ultra Violet Bulb Replacement
Step 1 Turn off the incoming water supply to the UV system.
Step 2 Unplug transformer from the power outlet and disconnect transformer wire harness
from the UV lamp at the plastic connector.
Step 3 Remove UV lamp from housing by pulling on the UV
wire harness away from the UV housing. Use caution
when removing lamp not to break glass. Discard of old
lamp.
Note:
DO NOT TOUCH NEW UV LAMP GLASS WITH BARE HANDS, THIS WILL
DAMAGE THE LAMP.
Step 4 Install new lamp by pushing it into the UV housing using the white end cap.
Step 5 Plug the (24 volt) transformer power cord connector into the UV module wire harness
connector and plug the transformer into an electrical outlet. The white UV end cap
will light up when in service (Plugged in).
Step 6
Turn on the incoming water supply to the UV system.
All manuals and user guides at all-guides.com
9