Filter Change - Watts Premier 500320 UV-3 Manuel D'installation, D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Filter Change

Premier recommends changing the filter element every 6 months. However filter life may vary
depending on local water conditions and water use.
Use Premier's replacement cartridge only. Other filters may look the same, but only filters
by Watts are manufactured to fit your filter unit in order to ensure proper reduction of water
contaminants.
Sediment Pre-Filter
Part# 104017
Carbon Block Filter
Part# 101015
(A) Turn off incoming water supply to the system.
Note: There will be water in the filter housing. Lift the
faucet handle to relieve the water pressure.
(B) Remove filter housing from lid by turning it to the left,
as shown in Figure D.
(C) Remove used filter cartridges and discard.
NOTE: Do not discard filter-housing o-ring.
(D) Clean inside of filter housing with warm soapy water
and rinse well to remove soap.
(E) Lubricate o-ring with water-soluble lubricant (i.e. K-Y
Jelly ®).
NOTE: Do not use Petroleum based lubricants such as Vaseline ®.
(F) Seat o-ring in groove in filter housing and insert new filter cartridges into appropriate filter
housing.
(G) Screw filter housing onto lid as shown in Figure D.
(H) Turn on water supply to filter unit check system for leaks periodically over the next 24-48
hours.
All manuals and user guides at all-guides.com
8
Figure D
Filter Lid
O-Ring
Filter
Filter Bowl
To
To
Tighten
Loosen

Publicité

Table des Matières
loading

Table des Matières