Operation; A Preparation; B Setting Up Appliance - Keimling FreshLife Mode D'emploi

Operation

A. Preparation
Before using your FreshLife
pg 25) were included and thoroughly clean all parts of the appliance (Caution! The water barrel and
the motor chamber are a unit and may never be immersed in water)
B. Setting up appliance
1. Fill sprout screen (3) with seeds
Rinse off a sprout screen under hot running
water Fill the sprout screen (smooth side
facing up) with seeds For smaller types of
seeds such as alfalfa, 5-6 tablespoons are
sufficient for a complete sprout screen
When you grow larger sprouts or grasses,
they also develop an amazingly extensive
root system In order to reduce the amount
of cleaning as far as possible, the reusable
white pads (9) included in delivery can be
placed underneath the seeds to prevent
the roots taking root in the sprout trays
Our recommendation: Start with mung
beans or lentils Sort out the bad seeds
By the way: You can, but do not have to,
steep the seeds before sprouting
Spread the seeds out evenly in a single
layer on the sprout tray (3)
2. Assembling the water tubes (4)
The water tubing of the FreshLife
sists of four water tube pieces (4) and a
sprinkler (a replacement sprinkler (2) is
also included in delivery)
a. First, you insert the water pressure con-
trol tube (6) into the middle of the water
barrel (7) By turning it anticlockwise, you
FreshLife Automatic Sprouter
®
® Automatic Sprouter for the first time, check that all individual parts (see
® con-
can increase the water pressure in case the
sprinkler does not turn when switched on
b. Place the appropriate water tube piece
onto the water pressure control tube Fill
the water barrel up to the marking with
water (approx 4 cm below the rim) and
place the sprout barrel (5) onto the water
barrel To do so, put the sprout barrel over
the two connected water tube pieces in the
water barrel
c. Assemble both remaining water tubes
as illustrated and insert them into the
middle of the sprout barrel Then put the
sprout screen filled with seeds over the
water tube and lay it into the sprout barrel
Fit the second sprout tray over the lower
sprout tray
You lay the second sprout screen into the
sprout barrel the same way (the smooth
side facing up) over the sprout screen (3)
that you already positioned
d. Finally, put the sprinkler (2) onto the end
of the water tube
29