Laserworld Proline Série Mode D'emploi page 13

Manual: Laserworld Proline Series
The syntax is like this:
FILENAME.ILD, 20, 300
FILENAM2.ILD, 30, 500
FILENAM3.ILD, 25, 10
The first entry is the name of the ILDA file, in the example, first row: FILENAME.ild
The second entry after the comma specifies the scan rate in kpps the ILDA file shall be
played at, in the example, first row: 20 (which means 20kpps)
The third value after the second comma specified the frame repetition rate and controls the
duration of the frame (and repetition speed of animated figures);, in the example, first row:
300
Using the ILDA files with the laser projector
Insert the SD card to the SD card slot of the laser. It can happen that it automatically re-
boots the laser if it's switched on at the time of card insertion. Select "SD Card" as operation
mode. Select the very folder you have created/want to use on the display.
Automatic playback of the whole folder:
If the control mode is set to "ILDA PRG", the whole folder is played back automatically, res-
pecting the play duration specified in the *.prg file. The playback loops.
Automatic playback of single ILDA files:
If the control mode is set to "ILDA Play", it is possible to select the very ILDA file that shall be
played back. Select it and the IDLA files will play in a loop.
Use the saved ILDA files over DMX control:
Set the DMX address in the address settings of the laser. Then use the following DMX chan-
nel settings to access the files individually:
Channel 1 values between:
Channel 2:
Channel 3:
page 13 / 42
150 – 199
select folder
select the ILDA files you have saved, one file per channel value.