Laserworld Proline Série Mode D'emploi page 11

Manual: Laserworld Proline Series
SD card:
This show laser system has an integrated SD card slot (a 2 GB SD card is included in the
delivery). It allows saving patterns, animations or shows as .ILD files on the SD card and
running them at the projector.
Insert the SD card into the card slot. Push the Menu button until MODE: SD PRG is
displayed. Press the ‚UP' and/or ‚DOWN' buttons to browse the mode and press ‚ENTER'
to select the desired program.
Information about the preset frames and animations on this SD Card
Certain frames and animations were created using Pangolin's Lasershow Designer
software, and Pangolin has granted us permission to include these with this projector.
To create similar content, check out Pangolin's QuickShow software, which is available
through Laserworld as an official distribution partner.
Go to http://www.laserworld.com/quickshow for more information.
Due to copyright regulations it is not permitted to copy any fames or animations from
this SD-card for other use. The copyright remains with their respective owner.
Master-Slave-Mode:
To use the daisy chain / Master-Slave-Mode connect two (or more) laser projectors of
the same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
Master projector
Select auto or
music mode at the
master projector
(see above)
ILDA control:
Connect your device („ILDA IN") via an ILDA cable to an interface / controller. Use a laser
control software, e.g. Phoenix or Pangolin, to run the device. Use „ILDA OUT" to connect
it to another device.
Settings:
Push the Menu button until MODE: SETTING is displayed. Press the ‚UP' and/or
‚DOWN' buttons to browse the setting which has to be changed (e.g. color, speed, etc.)
and press ‚ENTER' to select the setting. Press ‚ENTER' again to save the new setting.
page 11 / 42
DMX cable Slave projector
Push the Menu button until
MODE: SLAVE is displayed
and press ‚ENTER' to select the
slave mode.