Help And Support - HP LaserJet Tank MFP 160 Serie Guide De Référence

Help and tips for Wi-Fi and connectivity
If the software is unable to find your printer during setup, check the following conditions to resolve the issue.
Potential Issue
Printer Wi-Fi setup mode timed out (Wireless
light not blinking)
Computer or mobile device too far
from printer
Computer connected to a Virtual Private Network
(VPN) or remote work network
Wi-Fi turned off on computer
(computer connected by Ethernet)
Bluetooth is turned off on your computer
or mobile device
Location is turned off on your mobile device
The information herein is subject to change without notice.

Help and Support

For printer troubleshooting and videos, visit the
HP support site. Enter your model name to find
the printer.
Solution
If the Wireless light is not blinking blue, the printer might
not be in Wi-Fi setup mode. Restart setup mode:
1. If the control panel is not lit, press
mode.
2. Press and hold for 5 seconds, then release
once all the control panel buttons light up.
3. Press and at the same time once and then
release the buttons. Wait for one minute until the
Wireless light blinks blue.
4. Close and reopen HP Smart and try connecting
again.
Move your computer or mobile device closer to the
printer. Your device might be out of range of the
printer's Wi-Fi signal.
Disconnect from a VPN before installing HP Smart
software. You can't install apps from the Microsoft Store
when connected to a VPN. Connect to the VPN again after
finishing printer setup.
Note: Consider your location and the security of the Wi-Fi
network before disconnecting from a VPN.
If your computer is connected by Ethernet, turn on the
computer's Wi-Fi while setting up the printer. Disconnect
the Ethernet cable temporarily to complete setup over
Wi-Fi.
Turn on Bluetooth for the device being used to complete
setup. For mobile devices, turn on Location services
also. Bluetooth and Location help the software find your
network and printer.
Note: Your location is not being determined and no
location information is being sent to HP as part of the
setup process.
to exit sleep
hp.com/support
3