Axis Q8414-LVS Guide D'installation page 19

Set focus and zoom
Focus and zoom should only be configured when installing or reinstalling the product.
1. Go to Setup > Video & Audio.
2. On the focus page go to the Basic tab.
3. Set the zoom level using the slider.
Note
Movements in front of the camera should be avoided when performing autofocus.
4. Click Perform autofocus.
5. If the result is not satisfactory, go to the Advanced tab.
Note
Changing the zoom level moves the focus position. Focus should always be adjusted after
changing the zoom.
On the Advanced tab, focus can be adjusted manually:
1. Click Open iris to open the iris to its maximum position. This gives the smallest depth of
field and provides the best conditions for focusing.
2. Focus is set in the Focus window. Use the mouse to move and resize the focus window.
3. Click in the Focus position bar to focus on a desired location.
4. When satisfied, click Enable iris to enable the iris.
AXIS Q8414–LVS Network Camera
19
EN