Axis Q8414-LVS Guide D'installation page 11

10. If applicable: Pull the I/O cable through the I/O cable gasket before attaching the I/O
connector to the cable. Plug the I/O cable gasket into its hole. The gasket should fit
snugly with no folds or bends.
11. Attach the back chassis to the corner in the wall using screws appropriate for the wall
and ceiling material. The screws should go through the washers and the gaskets to
secure the IP66 sealing.
1
Cable gasket, network
2
Cable gasket, I/O
3
Screw (not included)
4
Washer
5
Gasket
12. For optimized sealing: Apply a strip of flexible gap filler / mastic sealant along the sides
of the back chassis. Ensure that any gaps between the back chassis and the ceiling /
walls are filled.
13. If applicable: Insert an SD card (not included) into the SD card slot on the camera
assembly.
14. If applicable: See Install AXIS T8642 Mounting Kit A (sold separately) on page 15.
15. If applicable: See Install AXIS Door Switch A for intrusion detection (sold separately)
on page 16
16. If applicable: See Install AXIS Q8414-LVS Smoked Dome (sold separately) on page 17.
17. If applicable: See Install AXIS Q8414-LVS IR Window B (sold separately) on page 17.
AXIS Q8414–LVS Network Camera
11
EN