Axis Q8414-LVS Guide D'installation page 15

4. Fold the top of the camera assembly upwards until the camera assembly is pressed
against the entire rim in the back chassis opening.
Important
Adjust the cable slack so that the cables are not squeezed between the sides of the camera
assembly and the back chassis.
5. Attach the camera assembly to the back chassis using the screws (torque 2.5 Nm).
NO TICE TICE
NO NO TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Install AXIS T8642 Mounting Kit A (sold separately)
The contents of this accessory kit makes it possible to mount an Ethernet Over Coax Adaptor (not
included) that enables camera installers to keep the legacy coax cabling when converting an analog
system to digital. It delivers standard PoE and centrally-sourced power with no new cables required.
1. Attach the angled BNC connector to the AXIS T8642 device.
2. Plug the network cable into the network connector on the AXIS T8642 device.
3. Guide the other end of the network cable through the cable tunnel to the back of the
camera assembly and plug the network cable into the network connector.
4. Guide the cable ties through the cable tunnels and attach the AXIS T8642 device to
the camera assembly.
AXIS Q8414–LVS Network Camera
15
EN