Axis Q8414-LVS Guide D'installation page 17

2. Attach the switch to the compartment using the screws.
3. Guide the I/O cable through the cable tunnel to the back of the camera assembly.
4. Snip off any excessive length from the I/O cable and fit the I/O connector block to the
I/O cable.
5. Plug the I/O connector block into the I/O connector.
Install AXIS Q8414-LVS Smoked Dome (sold separately)
1. Place the camera assembly with its front down on a raised surface, and ensure that the
dome glass does not touch any objects from this position.
2. Loosen the black screws (T20) that attach the camera holder to the back of the camera
assembly.
3. Unplug the microphone cable from the camera, pull the other end of the microphone
cable through the camera holder and remove the microphone cable from the camera
assembly.
4. Remove the camera holder from the back of the camera assembly.
5. Replace the clear glass dome in the front opening with a smoked glass dome.
6. Plug the microphone cable into the IR light window and drag the other end of the
microphone cable through the camera holder.
7. Place the camera holder in its original position on the back of the camera assembly.
Important
Ensure that the IR light window is positioned in its compartment and that the microphone cable
remains plugged into the IR light window.
8. Drag the microphone cable through the cable tunnel and connect the microphone cable
to the camera.
9. Tighten the black screws (T20, torque 2.5 Nm) to attach the camera holder to the camera
assembly.
Install AXIS Q8414-LVS IR Window B (sold separately)
This accessory kit is suitable for installations that do not require audio. The IR light windows are
not equipped with microphone holes.
1. Place the camera assembly with its front down on a raised surface, and ensure that the
dome glass does not touch any objects from this position.
2. Loosen the black screws (T20) that attach the camera holder to the back of the camera
assembly.
3. Unplug the microphone cable from the camera, pull the other end of the microphone
cable through the camera holder and remove the microphone cable from the camera
assembly.
4. Remove the camera holder from the back of the camera assembly.
5. Replace the IR light window in the front opening with an IR light window from the kit.
AXIS Q8414–LVS Network Camera
17
EN