STEINEL HBS 300 Consignes D'installation page 6

10
Setup & Commissioning
Lens Covers
Lens covers can be used to adjust the high
bay sensor's coverage as needed. The covers
are plastic and snap to the front of an HBS 300
or HBS 200.
LC4
10
20
30
40
30 ft 30 ft
22 ft 22 ft
LC4 reduced range lens
cover for HBS 300
10
20
30
40
LC1 aisle starter cover for HBS 200
www.steinel.net (800) 852-4343
All manuals and user guides at all-guides.com
LC5
10
20
30
40
35 ft 40 50
22 ft
LC5 180° half moon lens
cover for HBS 300
LC1
50 ft
53 ft
radial
tangential
Troubleshooting
Malfunction Cause
No power at the
breaker has tripped; light switch
sensor
is in OFF position
short circuit
Lights do not
light level setting is in nighttime
switch ON
mode during daytime operation
lamp burned out
power is off
detection zone not correctly adjusted
Lights do not
abundant heat from the fi xture is
switch OFF
within detection zone and keeps
lights on as a result of temperature
change
Lights keep
the fi xture is moving from side to side
switching ON/OFF
Lights switch ON
HVAC vent is causing air fl ow to
without obvious
switch lights on
movement
Warranty
STEINEL America warrants its products against
defects in material or workmanship for a period
of fi ve years. STEINEL will replace or repair
the item provided that it has not been altered
or subjected to abuse, accident, improper
installation or improper use. There are no
M-14101-1
Remedy
reset breaker, turn light switch
to ON position, check wiring
with voltage tester
check for proper wiring
connections
adjust light level setting
replace lamp
turn power on at circuit breaker
readjust
readjust zone or apply shroud
stabilize the fi xture
redirect air fl ow away from the
sensor
obligations or liabilities on the part of STEINEL
for consequential damages arising out of or in
connection with the use or performance of this
product or other indirect damages with respect
to loss of property, revenue, or profi t, or cost of
removal, installation or reinstallation.
www.steinel.net (800) 852-4343
11