Worx BladeRunner X2 Mode D'emploi page 11

WARNING: Some dust created by
power sanding, sawing, grinding,
drilling and other construction activities
contains chemicals known to the State
of California to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement
and other masonry products and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
WARNING: This product maybe
contains lead, phthalate or other
chemicals known to the State of
California to cause cancer, birth defects
and other reproductive harm. Please
wash your hands after use.
READ ALL INSTRUCTIONS
BEFORE USING THIS
APPLIANCE
INSTRUCTIONS PERTAINING TO RISK OF
INJURY
GENERAL
A. FOR ALL DOUBLE-INSULATED TOOLS
1. Replacement parts
When servicing use only identical
replacement parts.
2. Polarized Plugs
To reduce the risk of electric shock, this
equipment has a polarized plug (one blade
is wider than the other). This plug will fit
in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse
the plug. If it still does not fit, contact a
qualified electrician to install the proper
outlet. Do not change the plug in any way.
B. FOR ALL TOOLS AS APPLICABLE
1. KEEP GUARDS IN PLACE and in
working order.
BladeRunner
All manuals and user guides at all-guides.com
2. REMOVE ADJUSTING KEYS AND
3. KEEP WORK AREA CLEAN. Cluttered
4. DON'T USE IN DANGEROUS
5. KEEP CHILDREN AWAY. All visitors
6. MAKE WORKSHOP KID PROOF with
7. DON'T FORCE TOOL. It will do the job
8. USE RIGHT TOOL. Don't force tool or
9. USE PROPER EXTENSION CORD.
10. WEAR PROPER APPAREL. Do not wear
11. ALWAYS USE SAFETY GLASSES. Also
12. SECURE WORK. Use clamps or a vise to
13. DON'T OVERREACH. Keep proper
X2
®
WRENCHES. Form habit of checking to
see that keys and adjusting wrenches are
removed from tool before turning it on.
areas and benches invite accidents.
ENVIRONMENT. Don't use power tools
in damp or wet locations, or expose them
to rain. Keep work area well lighted.
should be kept at a safe distance from
work area.
padlocks, master switches, or by removing
starter keys.
better and safer at the rate for which it was
designed.
attachment to do a job for which it was not
designed.
Make sure your extension cord is in good
condition. When using an extension cord,
be sure to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. Table 1 shows the correct
size to use depending on cord length and
nameplate ampere rating. If in doubt, use
the next heavier gage. The smaller the
gage number, the heavier the cord.
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Nonslip footwear
is recommended. Wear protective hair
covering to contain long hair.
use face or dust mask if cutting operation
is dusty. Everyday eyeglasses only have
impact resistant lenses, they are NOT
safety glasses.
hold work when practical. It's safer than
using your hand and it frees both hands to
operate tool.
footing and balance at all times.
11
EN