Levoit LV600HH Mode D'emploi page 10

Use the Humidity Level
button to program a humidity
level for the humidifier.
1. Press the Humidity
2. Keep pressing the
FLASH 5x
3. Once you have selected
4. The device will start
EN
Level button once to
start programming. The
display will read "--."
Humidity Level button to
select a custom humidity
level between 40%-80%
RH.
your desired humidity,
the display will flash 5
times confirming your
selection.
producing mist and
automatically stop
operating once the
programmed humidity
level has been reached.
5. The device will resume
6. To exit out of the
NOTE:
• The programmed humidity level can be
changed at any time by pressing the humidity
level button.
• The "Set Humidity" icon will turn on while you
are setting your humidity level and will turn off
once your humidity level has been confirmed.
• Once you have programmed your humidity
level, the display will alternate every 3 seconds
between the programmed humidity and the
current humidity level during operation.
Press the Timer button to
set the timer anywhere from
1 to 12 hours. When you have
selected your desired time,
the display will flash three times before the
time is set. The device will automatically
turn off when the timer is finished counting
down. To cancel or turn off the timer, keep
pressing the Timer button until the display
flashes "--."
10
operation when the
relative humidity drops
5% below the set
humidity value.
humidity level function,
press and hold the
Humidity Level button
for 3 seconds.